![]() ![]() The back of the unit is mounted in the wall and houses the power supply unit and two 10A relays. I informed Sonoff of this shortcoming and they promised the final design will improve on that. The buttons at the bottom are large enough but the sample I got was very mushy with not a lot of feedback and it has to be pressed exactly in the middle. Right side sports the Sonoff logo and the bottom part houses a temperature sensor and a reset hole. The touchscreen plate with a striking metallic grey design is detachable from the power supply and relay part.Īt the front you see a touch screen sporting roomy 3.5 inches albeit with quite thick bezels and two switches. The EU version of NSPanel is sized as a standard EU switch made to fit 60mm electrical boxes. Sonoff NSPanel is now available only through Itead store. Kickstarter campaign is finished and funded. Expected MSRP once the campaign is finished is 75$. Sonoff NSPanel is available through Kickstarter for 50USD 54$ as a backer discount. The touch screen is here as a bonus, to give you additional information and control over other devices. Retaining the classic switches greatly increases usability and are more intuitive to less technically inclined users. Once I took it out of the box I literally yelped. The NSPanel got here in a matter of days and I eagerly opened it up. I was not about to decline that although my expectations were not that high, to be honest. Sonoff contacted me in August with an intriguing offer to test a touch-screen control switch. Shopping links in this article are affiliate links and I earn a small commission when you buy through them ![]() Review is not influenced by that fact and is solely my opinion. Some aspects of it might be changed once it reaches production. The Switch LED is on all the time, even when the switch is off so you can easily find the switch in the dark.Īlternatively, you can solder the switch LED on 3.3v and ground but then you can't control the LED, it is always on and very bright.Full disclosure: This is a pre production unit sent to me free of charge by Sonoff. Solder the switch LED where the Wi-Fi LED is and then you can control the LED by using the command LedPower ON. Control ON/OFF Leds on Sonoff Touch solution ~ The PSF-A85 in the Sonoff Touch does not have the external antenna connector soldered on. That is where the external antenna connector is located in the images above. ![]() Pay attention to the corner of the chip with three unused solder contacts. Note: Even if you have the PSF-A85 chip inside instead of a default ESP8285, the GPIO0 pin is in the same location. GPIO0 can be found on the right side of the ESP8285 and is the second pin from the bottom, as can be seen on the pictures. A connection between GPIO0 and GND needs to be made manually. The Sonoff Touch button is not connected to GPIO0 and hence cannot be used to bring the module into Programming Mode. Be sure to not touch it directly during the modifications. The touch sensor should be back in its intended place. The four serial pins (3V3, Rx, Tx, GND) can be seen in the pictures for the US version (left) and the EU version (right) of the module PCB.īe careful while removing and reassembling the top PCB. The hidden underside of the PCB contains the ESP8285 as shown in the pictures. Carefully remove the top PCB from the assembly. ![]() Please see the Hardware Preparation page for general instructions.Īs always, you need to access the serial interface. Unlike most Sonoff modules, the Sonoff Touch is based on the ESP8285 rather than the ESP8266. Smart Home Integrations Smart Home Integrations. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |